Persian report
PDF · 1.0 MB
Verifiable technical evidence
Fargah facade stone laboratory report
A sample of Fargah pressed facade stone was tested by the Central Laboratory of the Tehran Sand and Gravel Association, a laboratory approved by the General Office of Standards of Tehran Province. The original Persian and English reports are published here.
- Report issuer
- Central Laboratory of the Tehran Sand and Gravel Association
- Laboratory status
- Approved by the General Office of Standards of Tehran Province - licence 993/T
- Tested sample
- Fargah pressed building facade stone made from powder and aggregate, nominal size 400 × 400 × 30 mm
- Test references
- Iranian National Standard No. 755, ASTM C170 and ASTM D3967
- Report date
- 1404/05/11 (Solar Hijri)
ASTM C170 · ASTM D3967 · INSO 755
Reported test results
These values are transcribed from the supplied sample report. A dash means the report itself does not state an acceptance limit for that row.
| Test | Result | Stated acceptance limit |
|---|---|---|
| Flexural strength - average | 6.0 MPa | ≥ 5 MPa |
| Flexural strength - individual | 5.5 MPa | ≥ 4 MPa |
| Wide-wheel abrasion | 11.0 mm | ≤ 20 mm |
| Water absorption | 4.6% | — |
| Surface water absorption | 0.6 gr/cm² | ≤ 6 gr/cm² |
| Compressive strength - average | 35.0 MPa | — |
| Compressive strength - individual | 34.0 MPa | — |
| Brazilian resistance - average | 4.4 MPa | — |
| Brazilian resistance - individual | 2.8 MPa | — |
PDF · 1 page · signed scan
Signed source reports
Open or download the signed scan when you need the primary technical source.
English report
PDF · 1.0 MB
This page is a readable summary of the report for this specific sample. The signed PDF remains the primary source for technical or contractual decisions, and the results should not be generalised to every product or application without reviewing project conditions.
Quick answers
Where was Fargah stone tested?
At the Central Laboratory of the Tehran Sand and Gravel Association, identified in the report as approved by the General Office of Standards of Tehran Province under licence 993/T.
Which standards are referenced?
Iranian National Standard No. 755, ASTM C170 for compressive strength, and ASTM D3967 for Brazilian resistance are cited in the report.
Are the results within the stated acceptance limits?
Yes. Every row for which the report gives an acceptance limit records a result within that same limit.
Where can I download the source report?
The signed Persian and English scans can be opened or downloaded directly from this page.